Commands

These commands examine or modify the general model state. These are either settings that are saved/restored/reset along with the model, or general model controls that do not pertain to a specific module (like zone, structure elements, or ball).

Model Commands

model calm Calm the model.
model clean Clean the model.
model configure Configure an additional calculation mode.
model creep Set parameters for a creep material analysis.
model cycle Execute timesteps.
model deterministic Set the deterministic mode.
model display Set information to display during cycling.
model domain Specify the domain boundaries and conditions.
model dynamic Set parameters for a dynamic material analysis.
model energy Set the energy tracking state by process.
model factor-of-safety Set factor of safety analysis parameters.
model fluid Set parameters for a fluid flow analysis.
model gravity Set the gravity.
model history Create a history of a model quantity.
model largestrain Sets the program to use the numerical formulation for large-strain...
model list List a model related quantity.
model mechanical Set parameters for a mechanical analysis.
model new Clear model-state information.
model precision Set the listing precision.
model random Set the seed for the random-number generator.
model range Create/delete a named range.
model restore Restore program-state information.
model results Perform file operations on results files.
model save Save all model-state information.
model solve Solve to a specified limit.
model step Execute timesteps.
model thermal This command sets parameters for a thermal material analysis (only...
model title Set the model title.
model update-interval Set the number of cycles taken between updating the existing...